BBS水木清华站∶精华区

发信人: scaner (好好), 信区: Linux
标  题: LILO启动失败原因的判断方法
发信站: BBS 水木清华站 (Mon Aug  3 17:17:19 1998)

浏览了一下lilo的Readme，看见如下一段：

When LILO loads itself, it displays the word "LILO". Each letter is printed
before or after performing some specific action. If LILO fails at some
point, the letters printed so far can be used to identify the problem. This
is described in more detail in the technical overview.

想到常常有人问为什么Lilo启动时到了LI就
死机，是应为Linux 在启动时还要再装入一
个较大的启动模块，就是一般的/boot/boot.b
如果无法正常装入，就只出LI两个字母了。

下面是原文:
When LILO loads itself, it displays the word "LILO". Each letter is printed
before or after performing some specific action. If LILO fails at some
point, the letters printed so far can be used to identify the problem. This
is described in more detail in the technical overview.

Note that some hex digits may be inserted after the first "L" if a
transient disk problem occurs. Unless LILO stops at that point, generating
an endless stream of error codes, such hex digits do not indicate a severe
problem.

(<nothing>)  No part of LILO has been loaded. LILO either isn't installed
or the partition on which its boot sector is located isn't active.
L <error> ...   The first stage boot loader has been loaded and started,
but it can't load the second stage boot loader. The two-digit error
codes indicate the type of problem. (See also section "Disk error
codes".) This condition usually indicates a media failure or a geometry
mismatch (e.g. bad disk parameters, see section "Disk geometry").
LI   The first stage boot loader was able to load the second stage boot
loader, but has failed to execute it. This can either be caused by a
geometry mismatch or by moving /boot/boot.b without running the map
installer.
   LIL   The second stage boot loader has been started, but it can't load
    the descriptor table from the map file. This is typically caused by a
    media failure or by a geometry mismatch.
   LIL?   The second stage boot loader has been loaded at an incorrect
    address. This is typically caused by a subtle geometry mismatch or by
    moving /boot/boot.b without running the map installer.
   LIL-   The descriptor table is corrupt. This can either be caused by a
    geometry mismatch or by moving /boot/map without running the map
    installer.
   LILO   All parts of LILO have been successfully loaded.

--
#telnet I.want.to.go
telnet: Unable to connect to remote host: No Route to host

※ 来源:·BBS 水木清华站 bbs.net.tsinghua.edu.cn·[FROM: 202.119.79.71]